Disclosure: This page may contain affiliate links. Prices were checked on the date shown and may change.
An introduction to EVE Audio SC2070, based on information from the maker and distributors: what it does, how to use it and who it may suit. It is not scored.
The SC2070 combines the eminent technologies of the SC3070 and the TEC Award-winning SC4070 in a compact 2-way system.
— EVE Audio official site
What is SC2070?
The SC2070 is a two-way active midfield studio monitor from EVE Audio of Berlin. The maker says it combines technologies from the three-way SC3070 and SC4070 in a compact two-way system.
The tweeter is the newly developed Air Motion Transformer RS7, a ribbon-type unit with a folded diaphragm, crossing over at 1800 Hz, which is low for a two-way design. The maker says its diaphragm area is 1.5 times that of the SC207's tweeter.
A 6.5-inch SilverCone woofer with a honeycomb cone handles the lows. Total amplification is 250 W (100 W tweeter, 150 W woofer). Frequency range is 38 Hz to 25 kHz and maximum SPL per pair is 106 dB.
The front SMART-knob adjusts volume and filters and can lock settings. The input level can be set between 7 dBu and 22 dBu to make best use of the A/D converter.
New AMT RS7 tweeter
An Air Motion Transformer passes the signal current through a folded diaphragm to move air. The maker says the RS7 is the largest AMT used in a two-way monitor, which may interest those wanting to check high and upper-mid detail.
Low 1800 Hz crossover
Handover between tweeter and woofer sits at 1800 Hz. The maker says this aims at midrange imaging comparable to three-way systems.
6.5-inch SilverCone woofer
It has a copper-cap magnet system, a 1.5-inch voice coil and a light, stiff honeycomb cone, driven by two Class-D amplifiers for 250 W in total.
SMART-knob settings
The front knob adjusts volume and high-shelf (above 3 kHz), mid (1 kHz bell), desk (around 160 Hz) and low-shelf (below 300 Hz) filters in 0.5 dB steps, which may help compensate for desk or wall placement.
Parameter lock and safe fade-in
A parameter lock protects settings even when power is off, and a slow volume fade-in at power-on protects ears and equipment.
Input level and DSP
The maximum input level can be set from 7 dBu to 22 dBu to suit the A/D converter. The DSP serves the monitor's adjustments, all operable from the unit itself.
Specifications
| Item | Details |
|---|---|
| Type | Active 2-way midfield monitor |
| Tweeter | AMT RS7 (100 W) |
| Woofer | 6.5-inch SilverCone (150 W) |
| Passive radiator | 6.5-inch |
| Crossover frequency | 1800 Hz |
| Output power (per speaker) | 250 W |
| Frequency range (-3 dB, 1 m) | 38 Hz – 25 kHz |
| Max SPL (per pair) | 106 dB |
| Input level switch | +7 dBu / +22 dBu |
| Standby power | < 1 W |
| Maximum consumption | 170 VA |
| Dimensions (W x H x D) | 230 x 345 x 304 mm |
| Weight | 9.4 kg |
| Finish | Standard; All Black Edition available |
What is included and system requirements
- Monitor
- Filter control via SMART-knob
- All Black Edition available
- 5-year extended warranty for registered products (as listed)
How to use it
- Place the monitors left and right and angle them so the tweeters are at ear height.
- Connect the power cables.
- Connect your audio interface outputs to the monitor inputs.
- Set the input level to 7 dBu or 22 dBu to match your interface output.
- Switch on at low volume and raise it with the front knob.
- Press the knob to enter settings and adjust High, Mid, Desk and Low.
- Lock the settings when done.
- Press and hold the knob for three seconds to enter standby when not in use.
Mix and master checks
It may suit work where upper-mid and high detail matters.
Production in a smaller room
Filters for placement effects may make it worth considering for a room in a house.
Post-production and voice editing
It may serve for editing where the voice band needs close checking.
Who it may suit
- Home studio users who prioritize midrange imaging
- Those who find three-ways too big but want a higher-end two-way
- Anyone who wants to adjust desk and wall effects at the speaker
Good to know before you buy
- It is an active speaker and needs mains power.
- The maximum input level is adjusted between 7 dBu and 22 dBu.
- The official spec table includes subwoofer-related items; as a two-way monitor those may not apply.
How it differs from similar products
We do not pick a winner; the official figures are placed side by side.
SC3070
The SC2070 is a two-way with a 6.5-inch woofer, 1800 Hz crossover, 38 Hz to 25 kHz, 106 dB max SPL and 9.4 kg. The SC3070 is a three-way listing 35 Hz to 25 kHz, 110 dB, 335 W and 9.8 kg.
Price
Please check the official page for the price.
See SC2070 on the product page
Sources: eve-audio.com (checked 2026-10-27)
Comments