Disclosure: This page may contain affiliate links. Prices were checked on the date shown and may change.
An introduction to Apogee ClipMic digital 2, based on information from the maker and distributors: what it does, how to use it and who it may suit. It is not scored.
Don't let bad audio ruin a good story again.
— Apogee official site
What is ClipMic digital 2?
The ClipMic digital 2 is a wired lavalier microphone from Apogee, aimed at video creators, live streamers and video calls. It clips to a collar or similar to pick up the voice close to the mouth.
It has Apogee converters built in and outputs a digital signal. USB-A, USB-C and Lightning adapter cables are included, so it connects to computers, iPhone and iPad.
The maker says the wired design delivers better sound than wireless lavaliers. The cable is long enough to place the camera and keep the mic close to the speaker.
Gain is adjustable from 0 to 35 dB through the Apogee Maestro app or the MetaRecorder iOS app. MetaRecorder is provided as a free iOS recording app.
The ClipMic digital 2 is a wired lavalier mic for iPhone, iPad, macOS and Windows, described for video, streaming and calls.
The 1.2 m cable lets you place the camera away while keeping the mic near the speaker. For conferencing, the maker says headphones are not needed and it will not feed back through built-in speakers.
4 mm capsule
A 4 mm pre-polarized omnidirectional condenser capsule suits picking up the voice close to the mouth.
Built-in converters
Apogee converters are built in, supporting 44.1, 48, 88.2 and 96 kHz sample rates. The output is digital so it connects directly to computers and iPhone.
Low noise floor
The maker says the noise floor is low so the mic itself stays out of the recording. Equivalent noise level is -90 dBFS at minimum gain and -68 dBFS at maximum gain (A-weighted).
Gain control
Gain adjusts from 0 to 35 dB. Max SPL is 127 dB at minimum gain and 92 dB at maximum gain. Gain cannot be set from the native iOS camera app; use Maestro or MetaRecorder.
Multiple adapter cables
The mic cable is 1.2 m, with adapter cables for USB-A (1 m), USB-C (1 m) and Lightning (0.3 m), so you can choose to match your device.
Easy for video calls
According to the FAQ, headphones are not needed for conferencing apps and there is no feedback with built-in speakers. About 25 cm from the mouth is suggested as a starting point for setting gain.
How to set gain
Gain is set in the Apogee Maestro or MetaRecorder app, not from the iPhone's native camera app.
Placement starting point
The maker suggests about 25 cm (10 in) from the mouth as a starting point, adjusted to the situation.
Wired design
The maker says the wired design gives better sound quality than wireless lavaliers, and it avoids battery and interference worries.
Specifications
| Item | Details |
|---|---|
| Frequency response | 30 to 20,000 Hz |
| Gain range | 0 to 35 dB |
| Max SPL | 127 dB at minimum gain / 92 dB at maximum gain |
| Sensitivity | -46 dBFS at minimum gain / -11 dBFS at maximum gain (80 dB SPL, 1 kHz) |
| Equivalent noise level (A-weighted) | -90 dBFS at minimum gain / -68 dBFS at maximum gain |
| Sample rates | 44.1, 48, 88.2, 96 kHz |
| Capsule | 4 mm pre-polarized condenser, omnidirectional |
| Mic cable | 1.2 m (4 ft) |
| Adapter cables | USB-A 1 m, USB-C 1 m, Lightning 0.3 m |
| Suggested distance | About 25 cm (10 in) from the mouth |
| Gain apps | Apogee Maestro, MetaRecorder |
What is included and system requirements
- ClipMic digital 2 microphone with cable
- USB-A, USB-C and Lightning adapter cables
- Travel case with protective foam and cable organizer
- MetaRecorder (free iOS recording app)
- Compatible with iPhone, iPad, macOS and Windows
How to use it
- Clip the microphone to a collar or similar, around 25 cm from the mouth as a guide.
- Choose the adapter cable that matches your device.
- Connect the adapter cable to the microphone and the other end to the device.
- Set the input to ClipMic digital 2 in the computer's sound settings.
- On iPhone or iPad, launch the MetaRecorder app.
- Adjust gain in Maestro or MetaRecorder.
- Make a test recording and check the level.
- Store it in the included case after use.
Narration
It picks up the voice near the mouth, so it may be usable for narration.
Livestreaming and video shooting
As a lavalier it stays out of frame easily and may make it easier to separate camera and mic positions.
Video calls and meetings
The FAQ says headphones are not needed, so it may suit meetings.
Quick vocal sketches
The input notes mention singing, but on the official page I could read, the descriptions are mainly about speech and video.
Who it may suit
- Creators shooting video on iPhone or iPad
- People who want better voice quality for video calls or streams
- People who prefer not to rely on wireless lavaliers
Good to know before you buy
- Gain cannot be adjusted from the native iOS camera app; Maestro or MetaRecorder is required.
- The mic cable is 1.2 m.
- The official page's 'In The Box' section does not give a complete itemized list, so part of the package list is read from the feature and spec descriptions.
How it differs from similar products
We do not pick a winner; the official figures are placed side by side.
Apogee MiC Plus
The ClipMic digital 2 uses a 4 mm omnidirectional lavalier capsule with 0 to 35 dB gain and sample rates of 44.1 to 96 kHz. The MiC Plus is a cardioid condenser mic with a 46 dB preamp and 24-bit / up to 96 kHz.
Price
$199 (Apogee official site, checked 2026-10-27). Prices can vary by region and promotion, so check the official page before buying.
See ClipMic digital 2 on the product page
Sources: apogeedigital.com minet.jp (checked 2026-10-27)
Comments